Farwest Corrosion
Control Company
 

Home Products Services Contact Us Search Request Quote Order Online
 

    
Model RI-ICE Pack
I
mpressed Current Anode
from EDI


A Long Life Alternative to Magnesium Anodes for Cathodic Protection

Typical Applications
  • Replaces magnesium anodes for cathodic protection of underground structures.
  • Useful for spot protection in areas not adequately covered by primary system.
Features
  • Constant current output does not vary with seasonal variations in resistivity.
  • 20-year design life with proven high silicon iron anodes.
  • Direct hook-up to 115 Vac.
  • 120 or 240 mA output current.
  • Other sizes available on special order.

Packaging

  • 3" (8 cm) diameter cotton bag, 20" (50 cm) long'

Design Compatibility

    Model RI ICE Pack™ is a self-contained unit consisting of a constant current rectifier connected to a high silicon iron anode and packaged in a cotton bag containing calcined petroleum coke. The rectifier circuit is available in both half wave and full wave models. Half wave rectifiers are used for a structure electrically bonded to the power company grounding system. Full wave units are used when the structure is electrically isolated from the grounding system.

    This unique circuit does not generate heat; therefore, it is completely encapsulated in potting compound to protect it from the environment. Each ICE Pack can replace several magnesium anodes. With a design life of 20 years, it also eliminates one anode replacement cycle. ICE Pack is a cost-effective alternative for cathodically protecting any underground structure.

Performance Characteristics

The 120 mA and 240 mA models will maintain rated output in groundbeds up to about 50 ohms.

Anode voltage adjusts automatically to keep current at the rated level. To prevent a reduction of current output in high resistivity soil, the groundbed resistance can be reduced by increasing the length of the coke column.

Answers to Application Questions

Is the soil resistivity above 1000 ohm-cm?

With magnesium anodes, the output drops with increased soil resistivity. Typically, a 17 lb. mag anode will put out up to 100 mA in 1000 ohm-cm soil. With higher soil resistivities, additional mags are needed to maintain the required current output. However, with an ICE-Pack, a coke column can be designed to lower ground bed resistance, which provides you with the required current output. For example, if the soil resistivity is 25,000 ohm-cm, an ICE-Pack will produce 120 mA of current in a 7.5 ft. column of coke. For soil resistivities of 5000 ohm-cm and lower, no additional coke is necessary!

Have interference problems prevented you from installing a conventional impressed current system?

Each ICE-Pack will put out the same current as 1-2 magnesium anodes. Like a mag, it can be installed close to the structure so that the current output from the anode is less likely to be shielded by foreign structures.

Is 115 Vac power conveniently available?

The ICE-Pack is designed to operate with 115 Vac input. Up to twenty-five 125 mA ICE-Packs can be spliced onto a #12 AWG header cable which is terminated in a standard safety disconnect box. An ammeter or shunt, if required, can be installed in the box.

Are your installation costs increasing every time you replace a mag?

The ICE-Pack has a 20-year design life. A magnesium anode typically lasts 8-10 years. Each ICE-Pack eliminates at least one replacement cost and may save as many as two. The initial installation costs for either anode are about the same.
  

Cathodic Protection Products & Materials

 Impressed Anodes
 Sacrificial Anodes
 Cable & Splicing
 DC Supplies & Rectifiers
 Remote Monitoring
 Polarization Cells
 Overvoltage Protection
 Junction & Bond Boxes
 Test Stations & Markers
 Reference Electrodes
 Test Instruments
 Insulating Materials
 Pipe Coatings & Tape
 Miscellaneous Products

  

Cathodic Protection Services

 Farwest Engineering
 Farwest Installation

  

Cathodic Protection of Offshore Structures

 Galvanic CP Systems
 Impressed CP Systems
 Attachment Systems
 Monitoring Equipment

  

Marine Products Division

 Marine ICCP Systems
 Galvanic CP Materials
 Marine Growth Protection
 Electrolytic De-Scaling
 Electro-Chlorination

  

Pipeline Protection Products Division

 Epoxy Coatings
 Heat-Shrink Coatings
 Mastic Coatings
 Petrolatum Coatings
 Tape Coatings
 Surface Decontamination
 Moisture Seal Products
 Rockshields
 Inspection Instruments
 Insulated Fittings
 Insulators & Seals
 Flange Insulation
 Pipeline Cleaning Pigs
 Composite Systems
 Accessory Products
  

More Farwest
Website Resources

 Search this Website
 Request Quote
 Order Products Online
 View PDF Catalog
 Industry Links
 Farwest Suppliers
 Industry News
 Employment
 

Home

Products Services Search Request Quote Order Online

Farwest Corrosion Control Company
888-532-7937   (888-5FARWEST)

Tel: 

 310-532-9524
Fax:  310-532-3934

1480 West Artesia Blvd., Gardena, CA 90248-3215, USA
 www.farwestcorrosion.com

© 1996-2008 Farwest Corrosion Control Company | Privacy Statement
 

Integrity – Service – Quality
                  
... Since 1956